info@lgapplianceexperts.com Mon–Fri: 7am–8pm | Sat: 8am–6pm
844-612-0846
LG Refrigerator Moderate Severity
Er FS

Er FS – Freezer Temperature Sensor Error

LG Refrigerator Error Code

The freezer compartment NTC thermistor is out-of-range or open. The compressor may run continuously in an attempt to reach the set temperature. Thermistor replacement is a quick repair.

Quick Diagnosis Guide

1

Note the exact error code and any symptoms (sounds, smells, leaks)

2

Try power cycling the appliance (unplug for 60 seconds)

3

Check our diagnosis steps below

4

If code persists, call a certified technician

⚠ Professional Service Recommended
This error often involves electrical or sealed-system components. For safety, we recommend professional diagnosis.

What Does the LG Er FS Error Code Mean?

The freezer compartment NTC thermistor is out-of-range or open. The compressor may run continuously in an attempt to reach the set temperature. Thermistor replacement is a quick repair.

When your LG Refrigerator displays the Er FS code, it means the appliance's self-diagnostic system has detected a fault that requires attention. LG's smart diagnosis system is designed to surface this error only when the condition is confirmed — meaning a single power cycle that clears the code is not a reliable fix if the underlying cause has not been addressed.

Common Causes of the Er FS Error

Based on our technicians' experience servicing LG Refrigerators, the Er FS code is most frequently triggered by the following:

  • Component failure: A worn or failed internal part — motor, pump, sensor, or control board — is the most common root cause when this code appears repeatedly.
  • Blockage or restriction: Debris, lint, or mineral buildup in filters, hoses, or drain paths can trigger this error without any component failure.
  • Wiring or connector issue: Vibration over time can loosen harness connectors, causing intermittent faults that present as this error code.
  • Control board fault: Less commonly, the main control board or display board may misread sensor signals and generate a false Er FS error.
  • Installation issue: Improper leveling, restricted ventilation, or incorrect water supply pressure can cause the appliance to trigger error codes under normal operating conditions.

Step-by-Step Troubleshooting

Before scheduling a service call, work through the following steps in order. These checks resolve the Er FS error in a meaningful percentage of cases when the cause is a minor blockage or transient fault rather than a failed component.

  1. Power cycle the appliance. Unplug from the wall outlet — do not just press the power button — and leave it unplugged for a full 60 seconds. This clears the control board's active memory. Plug back in and run a short test cycle.
  2. Inspect and clean filters. Locate the filter or trap for your specific Refrigerator model (refer to the owner's manual for the exact location). Remove, rinse, and reinstall. A clogged filter is one of the most common causes of fault codes.
  3. Check hoses and connections. Inspect the drain hose, water inlet hose, and any visible connections for kinks, blockages, or loose fittings. Ensure the drain hose is not inserted more than 6 inches into the standpipe.
  4. Verify installation conditions. Confirm the appliance is level (use a spirit level — all four feet should contact the floor firmly), that there is adequate clearance for ventilation, and that water supply pressure is within the range specified in your manual.
  5. Run a diagnostic cycle. Many LG Refrigerator models support a built-in diagnostic mode. Consult your owner's manual for the key sequence. The diagnostic readout can narrow down which component is generating the fault.

When to Call a Professional

If the Er FS code returns after completing the steps above, a component has likely failed and the repair requires disassembly, professional diagnosis, and genuine LG OEM parts. Continuing to run the appliance with an active fault may cause secondary damage — for example, a failing drain pump that is not replaced can overheat and damage the motor or control board.

LG Appliance Experts technicians carry the most common replacement parts for LG Refrigerators on every service vehicle. In most cases, we can diagnose and complete the repair in a single visit.

Repair Cost Estimate

Repair costs for the Er FS error vary depending on which component has failed. Typical ranges based on our service history:

  • Blockage removal / filter cleaning: Covered under the diagnostic fee if no part is needed
  • Pump or motor replacement: $150–$350 including parts and labor
  • Sensor or harness repair: $100–$220 including parts and labor
  • Control board replacement: $200–$450 including parts and labor

All repairs include a 90-day parts and labor warranty. A written estimate is provided before any work begins.

Need a Technician?

Our certified LG technicians diagnose Er FS errors on the first visit.

Call 844-612-0846 Book Online

Related Service

LG Refrigerator Repair

Factory-certified LG technicians. Genuine OEM parts. 90-day warranty.

View service →
Error Code Directory

LG Refrigerator Error Codes

Complete list of LG Refrigerator error codes with diagnosis guides.

Code Meaning Severity Common Symptom
CF CF – Condenser Fan Motor Error Medium The condenser fan is not running. Without it, the compressor overheats and…
Er 1F Er 1F – Refrigerator Sensor 1 Error Medium Refrigerator compartment sensor 1 is faulty. Found on LG side-by-side and column…
Er 2F Er 2F – Refrigerator Sensor 2 Error Medium Refrigerator compartment sensor 2 (typically the return-air or ambient sensor) has failed.…
Er CO Er CO – Communication Error Medium The main control board has lost communication with the display board. This…
Er dH Er dH – Defrost Heater Error Medium The defrost heater circuit is open. Ice will accumulate on the evaporator…
Er FF Er FF – Freezer Fan Motor Error Medium The freezer evaporator fan motor is not operating. Without this fan, cold…
Er gF Er gF – Ice Maker Motor Error Medium The ice maker harvest motor or its gear assembly has failed. Ice…
Er HS Er HS – Humidity Sensor Error Medium The humidity sensor inside the fresh-food section is faulty. This sensor helps…
Er IF Er IF – Ice Maker Fan Error Medium The dedicated ice maker evaporator fan (on dual-evaporator models) is not running.…
Er IS Er IS – Ice Maker Sensor Error Medium The ice maker temperature sensor is faulty or out-of-range. The ice maker…
Er rF Er rF – Refrigerator Compartment Fan Error Medium The fresh-food section evaporator fan has failed. The refrigerator section will warm…
Frequently Asked Questions

Common LG Repair Questions

Answers to the most common questions our customers ask.

LG refrigerators commonly experience a sealed-system failure (linear compressor issue), a failed evaporator fan motor, or a defrost system failure causing the evaporator coils to ice over completely. LG linear compressors are covered by a 10-year parts warranty on many models — we can verify your coverage.

Water inside the fridge usually comes from a blocked defrost drain tube — ice forms in the drain pan and water overflows into the fresh-food section. Water under the fridge suggests a cracked or overflowing drain pan or a faulty ice maker water line. Both are same-day repairs.

Er dH means the defrost heater circuit is open or the defrost thermostat has failed. The evaporator coils will frost over completely, blocking all airflow and causing the unit to stop cooling. This is one of the most common LG refrigerator repairs and is typically a 1–2 hour job.

Yes. LG linear compressors in certain French Door models produced between 2014–2019 have an elevated failure rate. LG extended the compressor warranty to 10 years on affected models. Our technicians are certified to diagnose and replace LG compressors and can check your serial number for warranty eligibility.

The InstaView panel requires two quick knocks within 1 second to illuminate. If it stops responding, the InstaView board, the knock sensor, or the LED panel itself may have failed. This is an LG-specific repair that requires genuine LG InstaView components.

Common causes: the ice maker arm/bail is raised to the OFF position, the water supply shut-off behind the fridge is closed, a clogged water filter (replace every 6 months), a frozen fill tube, or a failed water inlet valve. We diagnose all LG ice maker types including Craft Ice and standard tray makers.

Still have questions? Our experts are standing by.

Call 844-612-0846
Book Your Repair

Schedule Your
Appliance Repair Today

Our factory-certified technicians are ready to diagnose and fix your appliance — often on the same day. Transparent pricing, genuine OEM parts, and a 90-day warranty on all repairs.

Free diagnosis with repair — no hidden fees
Same-day and next-day appointments available
Factory-certified technicians, genuine OEM parts
90-day parts and labor warranty on every job

Prefer to call?

844-612-0846

Mon–Fri: 7am–8pm | Sat: 8am–6pm

Request an Appointment

We'll confirm within 2 hours